img sending 'bootloader' (2970 KB) FAILED (remote: image is not a boot image) Jun 25, 2015. Auto or manual selection of memories and ranges to program: If you check this box, you can specify which firmware image MPLAB X should load in the box below. ![]() ![]() For each boot image that's distributed to the PXE DP and that will be used for PXE boot, make sure that the PXE option is enabled for each boot image. However, when trying to boot it, I only receive the following message: The selected boot device failed. all, We designed a custom LS1046A board with 4GB DDR4,which use 4 NT5AD512M16A4-HRI(512MBx16). Navigate to the Exit section and choose to Exit Saving Changes. Make sure Secure Boot is either Disabled or Off. ![]() It takes around 20-30 every Image Mounting A small number of customers reported that they could not mount Macrium Reflect images after dismounting a previously mounted image.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |